← Back to blog

Frac Tank Sizes and Capacity: How Much Water You're Really Heating

A standard frac tank holds 500 barrels (21,000 gallons). Here's what tank sizes mean for how much heat a winter frac job really needs.

When you plan a winter frac job, the number that drives your heating plan is the volume of water you have to bring up to temperature. That starts with the tanks. Here's what standard frac tank sizes look like and how they turn into a heating load.

Standard frac tank capacity: 500 barrels

Most frac tanks on location are 500-barrel (500 BBL) steel tanks, which hold about 21,000 gallons. They are trailer-mounted so a standard tractor can move them between pads.

Typical frac tank sizes and dimensions

Dimensions vary by manufacturer and design, but a 500 BBL tank usually runs about 42 to 51 feet long, about 8 to 8.5 feet wide and about 10 to 13 feet tall. Empty, they weigh roughly 26,000 to 30,000 pounds.

The common designs are closed-top tanks with a V-shaped or round bottom for full drain-out, open-top tanks for easy access, and insulated tanks. Insulated tanks lose less heat while water waits to be pumped, which matters in a Wyoming or North Dakota winter.

From tank count to heating load

Water weighs about 8.34 pounds per gallon, and it takes 1 BTU to raise 1 pound of water by 1°F. A full 21,000-gallon tank holds about 175,000 pounds of water. Raising it 1°F takes about 175,000 BTU.

So if your source water is 35°F and the fluid design calls for 75°F, that's a 40°F rise: about 7 million BTU per tank. Multiply by the number of tanks or barrels you'll pump per stage, and you have the heat your program needs before any losses to wind, cold lines or open tanks.

Batch heating vs. heating on the fly

You can heat water in the tanks ahead of time (batch heating) or heat it as it flows to the blender (on the fly). Batch heating needs more tanks and good insulation so the water stays warm. Heating on the fly needs enough heater output to keep up with your pump rate, which is why high-output heaters matter on large multi-well pads.

Questions to settle before you request a heating quote

Complete Heat runs 32M BTU tri-fuel frac heaters out of Buffalo, Wyoming. Send us your tank count and temperatures on our frac heaters page and we'll put together a custom quote.

Ready to talk frac water heating?

Call Jason for a quote: 307-217-1494